How do you swap a ps pump on a ls1 t/a?

[xrelapse13]

gonna be doing this tomorrow and could use some advice, tips, writeup, etc..

[98tadriver]

get a power steering pulley puller. pull the pulley off. then theres a few bolts that go into the block, take them out, dont forget to disconnect your lines too. its really not bad at all. just be careful with the pulley, its plastic

[xrelapse13]

oh wow lol, that really is simple. Specially after doing a cam swap. I just wanted to make sure there was nothing obscure in the swap. Won't have to worry bout the pulley since im putting on a turn one pump/pulley.

Thanks alot though man.

[xrelapse13]

what do i do with ps cooler though when itake it off? since doesn't it run through the coolant lines?

[V]

leave the ps cooler in place, just disconnect the low pressure line connected to the pump from it.

[xrelapse13]

sweet thanks alot.