|
Parting out my 355
Here are some left over parts from my motor I am building. here's the story. I was getting the motor freshened up. It only has 500 miles on it but it was sitting for 12 years between my garage and my friends garage. It was sealed up so there was no rust . Once the engine builder tore it down he discovered a few things that needed to be corrected. So rather than sink a whole bunch a money into an old motor it made more sense to build a new one. I used the block as a core so this is what is left:
1) Crane Energizer Cam Grind # 284 H12 Part # 100072 . Specs: advertised duration is 284. duration @ .050 is 228. Lift is .480 w/ 1.5 rocker arm/ .512 w/ 1.6. 2800-5800 RPM operating range. Cam lobes are all good. Lobe separation is 107 int/ 117 exh (same as 112). I have the cam card. $50 comes with lifters if you want them. They are numbered and in order.
2) set of 8 flat top pistons w/ 4 valve reliefs w/ stock rods. Rods need to be reconditioned. $75
3) Stock crank. good for core $25
6) Stock HEI distributor $30
Prices are flexible
Have pics of everything
Located in Hatboro,Pa
Last edited by dpmalibu; 03-04-2011 at 02:24 PM.
|
