4L60E Separator Plate Question

[LTb1ow]

I finally ordered a trans go plate, hopefully it matches mine and fixes that issue.

First question, can I reuse the separator plate gaskets? They are relatively new and are the trans go shift kit version. Other than a shift kit, I cannot seem to find new gaskets anywhere.

Second question, I have read that you can upgrade the stock check balls to a heavy duty steel shot to prevent them from getting stuck in plate. Thoughts on this?

For the curious, due to stock plate being teh suX0r, and a bumped line pressure, several check balls pushed through it. Which causes a lovely loss of line pressure and limp mode if you WOT nail it.

[Stevoone]

I have a gasket kit left over from a partial rebuild. Says its has both designs for Full annular port and non-full annular port valve bodies. Not sure what year or model they are from.

GM Part number is 24221350.

[LTb1ow]

Well, according to amazon, they should fit my application.

Would you be willing to sell me the gaskets?