4th Gen, "security" light in dash

[JohnG]

it stays on for about 2 - 3 minutes after I start the car...

everything runs/works fine, but can anyone tell me what might be going on ?

thanks in advance

[black95maro]

VATS bum bum bummmmmmmmm http://vats.likeabigdog.com/

[Tru2Chevy]

If it was VATS, I would think that the car wouldn't start at all....

- Justin

[black95maro]

Originally Posted by Tru2Chevy

If it was VATS, I would think that the car wouldn't start at all....

- Justin

thats what mine did too, few days later i couldn't start it.

[Savage_Messiah]

it'll do that when the key resistor is dirty or wearing down IIRC

[griftymcgrift]

unplug the battery for 10 minutes...no less. then plug it back in. resets the ecm. good luck.

[sweetbmxrider]

Originally Posted by griftymcgrift

unplug the battery for 10 minutes...no less. then plug it back in. resets the ecm. good luck.

its more like 25-30 minutes minimum. but that won't fix this problem. and i believe the security light works off of the bcm-body control module.

[Jersey_TA]

If it stays on and won't let you start the car pop the hood and pull the fuses for the computer. Let it sit for 20 seconds, put the fuses back in and the car should start no problem. You can install a resistor to bypass "trick" the VATS and it should work just fine. I had to do that on my car.

[firebirdcrazy]

That happened to me as well get to a dealer asap or your mechanic and get it fixed. Your going to get a new set of ignition keys after its done. This happened to me after like a week it started to give problems at start up. Then I got stuck at the train station where it didnt start at all and had to get towed.

[nj96z28]

is it a z28? if so, its probably ur factory alarm/ remote door lock controlller. the box for it is bottom engine bay under the driver's side. I wouldnt suggest screwing with it unless you have the platform manual. I have the entire copy , you are more than welcome to use mine.