Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Tech Forums > Electrical and Wiring

Notices


Reply
 
Thread Tools
Old 06-02-2009, 10:55 AM   #1
Pampered-Z
Sliderule / Moderator
 
Pampered-Z's Avatar
 
Join Date: Oct 2004
Location: Catawissa PA
Posts: 2,294
iTrader: (1)
AC blowing fuse.

2000 Chevy Tracker, 110K miles:

AC will run for anywhere from 1 minute to 30 minutes, then the fuse blows (25 amp fuse)

Replaced the relay, also pressure is good at 40 PSI. and temp out the vent is about 45 degrees.

Switch on dash seems fine, light come on when activated and stays on, I see constent power to the relay from the switch.

Any ideas what could be wrong that is causing this? Could it be one of the sensors or something in the compressor clutch?
__________________
93Z M6 Black: The 385 Lives! Supercharged, 3-core front mount intercooler, GTP heads, 3:73's, Street twin clutch, Jethot Longtubes, Mufflex 4" catback/spintech, S+W cage, Spohn Suspenion, Yada Yada Yada

1) Build it
2) Race it
3) Break it
4) Repeat!!!
Pampered-Z is offline   Reply With Quote
Old 06-02-2009, 11:10 AM   #2
madness410
 
madness410's Avatar
 
Join Date: Mar 2008
Location: Somerset, NJ
Posts: 4,223
iTrader: (5)
any spliced wires touching eachother? have you tried different amp fuses?
__________________
Jon
1999 Trans am WS6
1996 Corvette LT4 6 speed
madness410 is offline   Reply With Quote
Old 06-02-2009, 01:02 PM   #3
BonzoHansen
Admin.
 
BonzoHansen's Avatar
 
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,149
iTrader: (27)
Geez Sliderule, there are so many electrical parts now. 4wd or 2wd? 1.6 or 2.0?

Quote:
Originally Posted by madness410 View Post
have you tried different amp fuses?
__________________
Vent Windows Forever!

The looser the waistband, the deeper the quicksand. Or so I have read.

Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.

Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop
BonzoHansen is offline   Reply With Quote
Old 06-02-2009, 01:06 PM   #4
WildBillyT
Ayatollah of Rock N Rolla / Admin
 
WildBillyT's Avatar
 
Join Date: Mar 2006
Location: Parts Unknown
Posts: 12,573
iTrader: (10)
Quote:
Originally Posted by BonzoHansen View Post
WildBillyT is offline   Reply With Quote
Old 06-02-2009, 01:16 PM   #5
BonzoHansen
Admin.
 
BonzoHansen's Avatar
 
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,149
iTrader: (27)
2000 4x4 2.0L. I bet the HVAC is all the same. GFL. And it still might be the comp.

Fig. Ground, A/C and Pressure Switches


Fig. Compressor Clutch and Condenser Fan


Fig. Power, Thermister, ECT Sensor and PCM(c) (2000)


Fig. HVAC Blower Control Schematics


http://www.autozone.com/autozone/rep...00c1528024e63b
__________________
Vent Windows Forever!

The looser the waistband, the deeper the quicksand. Or so I have read.

Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.

Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop
BonzoHansen is offline   Reply With Quote
Old 06-02-2009, 01:20 PM   #6
BonzoHansen
Admin.
 
BonzoHansen's Avatar
 
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,149
iTrader: (27)
Googling...no help...

http://autorepair.about.com/library/faqs/bl492f.htm
http://en.allexperts.com/q/Suzuki-799/tracker-c.htm
http://www.justanswer.com/questions/...-keeps-blowing
__________________
Vent Windows Forever!

The looser the waistband, the deeper the quicksand. Or so I have read.

Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.

Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop
BonzoHansen is offline   Reply With Quote
Old 06-02-2009, 01:36 PM   #7
sweetbmxrider
Meet Coordinator
 
sweetbmxrider's Avatar
 
Join Date: Jan 2008
Location: brick/pt. pleasant beach
Posts: 19,341
iTrader: (12)
which relay did you replace? looks like it could be the fan going out and drawing too much amperage.

__________________
sweetbmxrider is offline   Reply With Quote
Old 06-02-2009, 01:37 PM   #8
BonzoHansen
Admin.
 
BonzoHansen's Avatar
 
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,149
iTrader: (27)
Fan appears to have its own 60 amp fuse
__________________
Vent Windows Forever!

The looser the waistband, the deeper the quicksand. Or so I have read.

Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.

Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop
BonzoHansen is offline   Reply With Quote
Old 06-02-2009, 01:55 PM   #9
sweetbmxrider
Meet Coordinator
 
sweetbmxrider's Avatar
 
Join Date: Jan 2008
Location: brick/pt. pleasant beach
Posts: 19,341
iTrader: (12)
i must be reading it wrong. i only see in the 2nd diagram the 25 amp "a/c" fuse which both the clutch and fan relays seem to feed through.

i didn't see any TSB's

what motor btw?
__________________
sweetbmxrider is offline   Reply With Quote
Old 06-02-2009, 01:59 PM   #10
BonzoHansen
Admin.
 
BonzoHansen's Avatar
 
Join Date: Aug 2005
Location: Hamilton, NJ
Posts: 20,149
iTrader: (27)
oh the condenser fan. I was looking at the blower fan. If that is the fuse going I'd check the fan for a short
__________________
Vent Windows Forever!

The looser the waistband, the deeper the quicksand. Or so I have read.

Feather-light suspension, Konis just couldn't hold. I'm so glad I took a look inside your showroom doors.

Hey everybody, it's good to have you on the Baba-too-da-ba-too-ba-ba-buh-doo-ga-ga-bop-a-dop
BonzoHansen is offline   Reply With Quote
Old 06-02-2009, 08:46 PM   #11
//<86TA>\\
Power Member
 
//<86TA>\\'s Avatar
 
Join Date: Oct 2007
Location: Milford NJ
Posts: 1,526
iTrader: (1)
Quote:
Originally Posted by madness410 View Post
have you tried different amp fuses?
thats a really good way to start a fire....
//<86TA>\\ is offline   Reply With Quote
Old 06-03-2009, 02:36 PM   #12
Pampered-Z
Sliderule / Moderator
 
Pampered-Z's Avatar
 
Join Date: Oct 2004
Location: Catawissa PA
Posts: 2,294
iTrader: (1)
4WD 2.0 motor.

One thing I didn't take notice of is if the fan turns on when the compressor activates. The actual blower motor is fine and continues to run. When the fuse blows the compressor shuts off (and of course then the AC blows warm air).

I replaced the AC compressor relay. Guess I need to check the fan relay as well.
__________________
93Z M6 Black: The 385 Lives! Supercharged, 3-core front mount intercooler, GTP heads, 3:73's, Street twin clutch, Jethot Longtubes, Mufflex 4" catback/spintech, S+W cage, Spohn Suspenion, Yada Yada Yada

1) Build it
2) Race it
3) Break it
4) Repeat!!!
Pampered-Z is offline   Reply With Quote
Old 06-03-2009, 04:19 PM   #13
ZeroCool8891
 
ZeroCool8891's Avatar
 
Join Date: Apr 2006
Location: Landing, NJ
Posts: 1,042
iTrader: (17)
i remember when i was at the dealer, same car had the same prob, replace the heater control and it was fine after that, but you would want to check everything before you decide to go that route.
__________________
87 Trans Am 5.7, Auto, posi disc rear, flowmaster muffler, all org car.
88 Iroc-Z TPI, Cammed 350, Vortex Heads, Magnaflow, T5, 4 Wheel Disc, 3.27 9 Bolt PBR.
91 Trans Am VertTPI 350. 700r4, K&N Air Cone, Ryven Muffler.
ZeroCool8891 is offline   Reply With Quote
Old 06-04-2009, 09:03 AM   #14
Pampered-Z
Sliderule / Moderator
 
Pampered-Z's Avatar
 
Join Date: Oct 2004
Location: Catawissa PA
Posts: 2,294
iTrader: (1)
Quote:
Originally Posted by 88 Iroc Vert View Post
i remember when i was at the dealer, same car had the same prob, replace the heater control and it was fine after that, but you would want to check everything before you decide to go that route.
Thanks, I read that the switch is a major job to replace, have to take most of the dash apart!
__________________
93Z M6 Black: The 385 Lives! Supercharged, 3-core front mount intercooler, GTP heads, 3:73's, Street twin clutch, Jethot Longtubes, Mufflex 4" catback/spintech, S+W cage, Spohn Suspenion, Yada Yada Yada

1) Build it
2) Race it
3) Break it
4) Repeat!!!
Pampered-Z is offline   Reply With Quote
Old 06-05-2009, 01:55 PM   #15
ZeroCool8891
 
ZeroCool8891's Avatar
 
Join Date: Apr 2006
Location: Landing, NJ
Posts: 1,042
iTrader: (17)
Quote:
Originally Posted by Pampered-Z View Post
Thanks, I read that the switch is a major job to replace, have to take most of the dash apart!
yep, i hated it so much i did more then one, NIGHTMARE. Well good luck with yours.
__________________
87 Trans Am 5.7, Auto, posi disc rear, flowmaster muffler, all org car.
88 Iroc-Z TPI, Cammed 350, Vortex Heads, Magnaflow, T5, 4 Wheel Disc, 3.27 9 Bolt PBR.
91 Trans Am VertTPI 350. 700r4, K&N Air Cone, Ryven Muffler.
ZeroCool8891 is offline   Reply With Quote
Reply

  NJFBOA - Home of New Jersey's Camaros and Firebirds > Tech Forums > Electrical and Wiring


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

» Sponsor List














All times are GMT -5. The time now is 02:29 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.