Someones still looking out for the LT-1 People

[ar0ck]

One of MSD's new pieces :

MSD GM LT-1 Distributor Cap/Rotor

Finally a high quality Cap and Rotor for the front mount LT-1 distributor! LT-1 fans have been searching for a cap that could deliver the performance of the LT-1 and MSD is happy to bring it to them. Remember, changing the cap and rotor on this engine is no walk in the park. So when you do it, you want to make sure to install the best parts possible and the MSD Cap and Rotor deliver.
The all new cap housing is injection molded from a special Dupont material that provides extreme strength and high dielectric properties resulting in less chance of breakdown causing a misfire. The terminal paths are encased in a durable epoxy compound for even more protection. The rotor is also an all new molded piece with a brass/stainless rotor tip design.
Two models are available to cover all your LT-1 needs!

LT-1 Distributor Cap and Rotor Kit ’93-’94
PN 8481

LT-1 Distributor Cap and Rotor Kit ’95-’97
PN 84811

It goes for $150.88 from www.summitracing.com

http://store.summitracing.com/partde...=KeywordSearch

Looks like a nice piece, maybe it would work nice combined with a Delteq system, since they havent completely removed the Opti itself yet.

[Squirrel]

the cap and rotor part is the cause of all the problems only 70 or so percent of the time, but an MSD C&R combined with a new GM opti could be a promising combo 8)

[j0n]

i may hafta spring for that...good find!