exhaust tubing and bends
so i bought myself a welder and have some determination. i want to weld up an exhaust for my third gen. my y pipe is in good condition, i have a borla XR1 i want to run where the cat is normally. then i just need tubing from there to the axle where it will connect into the back half of a SLP loudmouth catback.
what i need is some tubing.. about 3ft of 3in strait tubing and 2 3in 45* bends, not sure where to get them from would prefer local as i want to take a stab at it this weekend.
i would think NAPA would be where i want to go but their website is useless for searching. autozone and advanced both seem to not have what i want/need and pep boys is in the same boat as napa with a shoddy search engine.
so what suggestions do you have? doesnt need to be stainless either.
__________________
2002 Camaro Sunset Orange Mettalic, V6, 5spd, bilstein HD shocks and struts, eibach pro lowering kit, eibach f/r sway bars, lakewood PHB, UMI 2 point subframe connectors, energy suspensions poly master bushing kit
daily econobox and first car
1986 IROC-Z, T56, MGW shifter, Heads, Cam, Holley Stealth Ram 350, t-top, tubular LCA with relo brackets, adjustable PHB, belltech sway bars, ground control weight jacks, SLP mid length headers, 3in w/borla XR1, RIP 3 10 bolts, 12.7 @ 109 so far.. atleast its faster than stock SOLD
1971 Camaro LS3/T56/9in, cam only and still carbed, RIP 2 10 bolts, 11.62@121
03 Blazer 2 door - salt sponge
|