my speakersgoboom now too

[GP99GT]

Installed my 2 12" Pioneer 400wRMS/800wMax dual voice coil subs, soundstream xtreme 440x2 @ 2ohm amp, and 2.2 farad capacitor today...now i get to annoy people bwahahaha....it sounds sweet though, better than the 10's i had before. i dont know what the point of this post is

[ar0ck]

What a ricer


My speakers will go boom on January1st, when my new head-unit gets installed, so I can finally rock out to my Dr. Dre 2001 CD.

[GP99GT]

i know im a ricer...speaking of which, i saw pats lincoln on my way home from best buy today, and i had to stop....i wrote ricer in the dirt on the windshield

[its Jeanne-Marie]

haha you jerk. we get in the car and pat goes what the ****? what does that even say?? i was like aww it says ricer. then we looked at each other and both said "Matt."

but why didn't you stop in the store and say hi to him?

[V]

ah somebdy else finally discovered soundstream, a not too well now company with some sick products. My system has some "bump" to it, Pioneer head unit, Alpine 470w 4ch powering JL interiors, and a 1000w Kenwood(temp replacement for my 1500w Alpine getting repaired) powering 2 12" Soundstream Mules. The advertisemnet about those subs are "Other subs may knock you out, but the Mules will kick your ass!"

I have a question about the capacitor, did you actually require it? i dunno but all the systems ive done, i've never needed one. i see kids all the time running way less power and they have them and i can never see why. At 2/3 volume my lights wil barely dim at night, nothing noticeable even on the batt. gauge. I learned with proper wiring, grounds and gauge sizes, power will flow correctly.

oh also, how are you running those dvc subs, stereo or bridged? If you do bridge them the ohm rating will be, i think 1, and that gets a little low for some soudstream amps so be careful. voice coils are all usually 4 ohms, with a dvc setup it drops the ohm of a sub to 2, so you should be getting approx 440w per channel. And with the 400w RMS of the subs, that will be good, as a rule you dont want to underpower a sub which can damage it just like overpowering it.

[Savage_Messiah]

but, aren't you selling soon?

[12secondv6]

Originally Posted by GP99GT

i know im a ricer...speaking of which, i saw pats lincoln on my way home from best buy today, and i had to stop....i wrote ricer in the dirt on the windshield

OWNED!

[skorpion317]

douchebag, you could have at least stopped in and said hi.

[GP99GT]

Originally Posted by Savage_Messiah

but, aren't you selling soon?

yeah, but i had all the equipment laying around...so i decided to put it in. its easier to take out than it is to put in, so when i find a buyer ill just yank it all.

and yeah Smoking, i have it running stereo, wired in ummm...i dont remember if its parallel or series....all +'s are together, all -'s are together. so yeah its running at 2 ohms. its definitly louder than i expected. and as for the capacitor, im not sure if i really NEED it, but its not like itll hurt anything to have it....it might prolong the life of my alternator/battery as well. im using all 4 gauge wire for power and grounds, grounded at the rear strut mount bolt.

[camaro2you]

i got some 330w pioneers 6x9
they did go boom now my motors out so there at rest till spring

[Teds89IROC]

my speakersgoboom too, 2 10" rockford fosgate punch HE2's, 400rms, 800max powered by a rockford fosgate punch series 800 watt 2 channel amp. it's rated at 800 watts, but it really puts out 912, according to the birth sheet. and I only have the gain at like 70%, maybe not even.

~Ted

[GP99GT]

yeah, 800w/912w with no resistance....factor in the ohm load the amp is at (probably 4 or 2) and its cut waaaaay down.

[slasherbarb]

will be putting my system in soon too...have 2 12" Rockford HE's with a Logic Soundland 500w amp(but that will be gone soon...want a nice Rockford amp) and a 1 farad Rockford digital cap...all off the a Pioneer head unit(already installed)...if anyone knows someone selling a Rockford amp(about 500w bridged will be perfect) let me know

[Teds89IROC]

Originally Posted by GP99GT

yeah, 800w/912w with no resistance....factor in the ohm load the amp is at (probably 4 or 2) and its cut waaaaay down.

probably, but the gain is barely over half and I can't set the "bass boost" up all the way and have the amp setting on my HU at super bass w/out blowing out my ear drums. I can still go half again louder than what I have it at now..way overkill lol

~Ted

[GP99GT]

Originally Posted by Teds89IROC

probably, but the gain is barely over half and I can't set the "bass boost" up all the way and have the amp setting on my HU at super bass w/out blowing out my ear drums. I can still go half again louder than what I have it at now..way overkill lol

~Ted

yeah i have to adjust mine, some of the songs i listen to are just all bass with a little highs sneaking in here and there....i think the gain is up a little high lmao