Two step questions

[LTb1ow]

Since I love adding in more electronic boxes and being slow...

I could have a two step wired off the line lock switch correct?

So, arm line lock which would arm MSD.. floor it to first stage rev limit, release line lock button, and break ten bolt?

[sweetbmxrider]

2step in the burnout box?

[LTb1ow]

Originally Posted by sweetbmxrider

2step in the burnout box?

I could, or just wire in an arm switch for two step.

[BarneyMobile]

I don't see a 2step being benificial in your setup.

[JSPERFORMANCE]

I assume you are trying to add some kind of launch control? You could do that but the low RPM setting would have to be far enough below your stall speed that it wouldnt push through the beams..

[LTb1ow]

Originally Posted by JSPERFORMANCE

I assume you are trying to add some kind of launch control? You could do that but the low RPM setting would have to be far enough below your stall speed that it wouldnt push through the beams..

Yea, pretty much, and I got a 4000 stall, shouldn't be an issue finding a good RPM under than.

[JSPERFORMANCE]

It will just be some trial and error to find out where it will hold the car to and what RPM the car leaves the best without blowing the tires off..

[sweetbmxrider]

Or breaking.....everything.....twice.