Random Question

[Knipps]

Anyone know why my wipers don't make full contact with my windsheild?
i replaced the blades b/c they sucked ass and i only noticed it with the new ones...
it's not just one blade, they both do it and its missing contact in the middle i guess?
i believe i got the right length and they're not ****** quality so idk wtf is up

[johnjzjz]

we place the wipers in the mid point of w/ shield buy turning the key off on them wet -- than taking the arm w/ the blade and bend it ( twist ) so as the blade center is 90* to the shield -- if you look at the blade when you stop it you will see on yours its bent over on its side not standing up straight -- the bending is to end up with the blade to be standing up straight in mid shield -- i hope you get what i mean its easy -- jz

[Knipps]

uhhhhh....
i think i may understand [can anyone else help just in case?]
& wtf would have caused this?

[Savage_Messiah]

i think he meant...

turn the car off with the wipers half way up, then look at it and make sure the blade (the rubber part itself) is at a 90* angle to the windshield. If not, bend it whichever way to fix it.

[j0n]

what brand wipers? i put some of the more expensive ones on my car and had the same problem due to the wiper arm not clearing the wipers...after a ton of grinding they worked fine...but your best bet is to get antoehr set of wipers

[BluMaj24]

random comment...j0n, I like your sig banner. Where'd ya get it?

Back to wipers... Did you get them fixed?

[Tru2Chevy]

Originally Posted by BluMaj24

random comment...j0n, I like your sig banner. Where'd ya get it?

http://ubanimator.com/

- Justin

[Knipps]

Originally Posted by j0n

what brand wipers?

RainX; walmart, go figure

haven't been home to fix them but i do get to take a 4 hour bus ride today to get there
****ing boston....

[Transambob027]

thats why walmart suck i know i work their 8) :P