heater blower troubles
 

My heater motor won't blow on high. I replaced the relay and I'm having the same problem. The fan has 1-2-3-4 settings and it will blow on 1 and 3 but if it's on 2 or 4 it doesn't blow at all. One of the prongs in the relay was burned up a little so I traced the corresponding wire going back to the fire wall and I don't see any other problems. Any suggestions?

Did you pull the heater blower motor resistor? I would check that next if you didnt.

I agree. Sounds like the blower resistor.

def. the resistor. i had the same problem with my 68 except it was only high and low lol.. no in between

interesting, where is the resistor?

probably right on top of the heater core on the inside of the car. at least thats where it is on mine, not too sure bout where yours would be located

found this

apparently the resistor is only used for the lower 3 speeds on the heater for your car. try this out

Find the blower motor high speed relay. It will be a small box near the blower itself. You can follow the thick purple wire from the blower to the relay. The relay will have a couple of small wires, the thick purple one, and a thick red one. The red one feeds raw battery to the relay, which then feeds it to the motor, thereby bypassing the ENTIRE rest of the car's wiring and delivering the highest possible voltage to the blower. Or, maybe not.... follow the red wire away from the relay. It will go up, to the windshield cowl, and over toward the driver's side. About at the point where it reaches the pass side valve cover, you will find a connector. Disconnect that extremely stupidly designed connector and observe that it has burnt completely to ashes, like everybody else's. There's your problem, same as everbody else.

Cut that idiotic thing off; and replace it with a pair of the BIG THICK HEAVY-DUTY yellow slide terminals. Not, the little weenie ones that are just like the blue and red ones except with a yellow barrel; look for the BIG THICK HEAVY-DUTY ones. Try to find insulated ones if possible. If not, cover the outer one with a piece of heat shrink.

Thanks a lot camaroguy! That connector was actually unplugged :doh: I think I had that unplugged to get at the under-hood light connection when I put the SS hood on, guess I forgot to plug it back in :lol:

awesome. glad it worked