any ideas what this is to?
 

hey guys. im doing a water pump job on a 1994 Camaro 3.4L v6 automatic. i pulled the stock intake off and found this connector laying on the frame. Any clue what it could be to? i looked around and didnt see any disconnected sensors(other than the ones i disconnected) or any where it would even plug in at. wiring goes back behind the abs unit and ties into the main harness that runs under the abs unit.

3 prong connector 2 red and 1 black wire.

http://i11.photobucket.com/albums/a1...00716-1835.jpg

http://i11.photobucket.com/albums/a1...00716-1835.jpg

shouldn't there be some type of air pump in that opening below where the sensor goes?

i didnt see any air pump stuff under that side. i know there is stuff in the passanger side fender well.

i dont remember any air pump on my 93 z because that was where i had my slp intake filters at. but the ls1 i know has a pump in the driver side

car run good w.o it? not necessary:nod:

yea no lights and runs good lol. i was just wondering what it went to.