Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Search Forums
Reload this Page Search Results
Home Register FAQ Today's Posts Search

Notices


Page 3 of 8 12 3 4567 Last »
Showing results 51 to 75 of 192
Search took 0.02 seconds; generated 96 minute(s) ago. Search: Posts Made By: Fasterthanyou
Forum: In Car Entertainment 06-22-2005, 03:03 PM
Replies: 10
Views: 3,816
Posted By Fasterthanyou
There are only 3 classes of speakers; 1st is the...

There are only 3 classes of speakers; 1st is the ultra expensive $250 for a pair MB Quart, Focal, etc. 2nd is the plastic/composite with lots of eye candy (everything in Crutchfield catalog and Best...
Forum: Electrical and Wiring 06-22-2005, 10:51 AM
Replies: 2
Views: 5,624
Posted By Fasterthanyou
Your numbers seem fine but what did you do about...

Your numbers seem fine but what did you do about the wiring harness? Did you swap or repin or neither?
Forum: Engine / Power / Tuning 06-22-2005, 12:06 AM
Replies: 14
Views: 6,330
Posted By Fasterthanyou
If you're looking for a motor on the cheap and...

If you're looking for a motor on the cheap and looking to make less than 400hp with no power adders then talk to Tim. He's probably got a long-block you could pick up on the cheap and get rebuilt....
Forum: Engine / Power / Tuning 06-20-2005, 03:47 PM
Replies: 9
Views: 3,367
Posted By Fasterthanyou
It's actually #3 and partly #1 but more of #4 ...

It's actually #3 and partly #1 but more of #4
#4; keeps the engine from heat soaking the hood which would in turn (while moving down the road) heat up the outside of your windshield.
Forum: Electrical and Wiring 06-19-2005, 10:54 PM
Replies: 5
Views: 6,269
Posted By Fasterthanyou
He got into an accident that probably totalled...

He got into an accident that probably totalled the car :( . Only a week after we got done with the SD tuning. He got a best mpg, 21.8 average when in above his normal traffic. Nothing was changed...
Forum: Engine / Power / Tuning 06-15-2005, 12:36 AM
Replies: 3
Views: 2,821
Posted By Fasterthanyou
He can't do that unless he wants to make 1 run...

He can't do that unless he wants to make 1 run before blowing the head gasket. Unlike Lt_'s the stock gen1 sbc has belt driven water pumps. The serpentine belt in the later year 3rd gens make it even...
Forum: Engine / Power / Tuning 06-14-2005, 12:37 AM
Replies: 3
Views: 3,474
Posted By Fasterthanyou
Hmm... ported Lt1's outflowing stock Lt4's......

Hmm... ported Lt1's outflowing stock Lt4's... yeah I could see that but what about ported Lt4's :P .
I'd go with the best designed heads since they'll give you the best potential. The Lt4 heads are...
Forum: Electrical and Wiring 06-12-2005, 10:31 PM
Replies: 5
Views: 6,269
Posted By Fasterthanyou
96 Imp to OBD-I is awesome

So other than the tach registering double the actual RPM (pcm see's it fine) the car is awesome. Even got to tuning it in SD mode with the MAF in the trunk. We're doing a gas mileage test to prove...
Forum: Brake, Chassis and Suspension Tech 06-12-2005, 01:25 AM
Replies: 8
Views: 3,955
Posted By Fasterthanyou
Pretty good if you don't mind fixing their...

Pretty good if you don't mind fixing their mistakes before you install it.
http://www.thirdgen.org/techbb2/showthread.php?s=&threadid=262176&highlight=edelbrock+torque+arm
There are more stories...
Forum: Transmission and Driveline 06-10-2005, 05:39 AM
Replies: 25
Views: 6,592
Posted By Fasterthanyou
You'll be fine with the stock shifter. I'm fine...

You'll be fine with the stock shifter. I'm fine with it and I don't consider myself super human when it comes to driving skills. The only shift that takes practice is the 1-2 since 1st gear happens...
Forum: Engine / Power / Tuning 06-09-2005, 06:18 PM
Replies: 10
Views: 3,398
Posted By Fasterthanyou
Sunday works for me but there is some kind of...

Sunday works for me but there is some kind of Strawberry festival going on that I already paid for... damn these scouts and their pre-paid tickets :wink: . Although all you can eat Strawberry's is...
Forum: Engine / Power / Tuning 06-08-2005, 10:09 PM
Replies: 10
Views: 3,398
Posted By Fasterthanyou
Viton is the way to go. Teflon should only be...

Viton is the way to go. Teflon should only be used for hard block engines where the head temps MIGHT get too hot for Viton.
Forum: Engine / Power / Tuning 06-08-2005, 06:16 PM
Replies: 10
Views: 3,398
Posted By Fasterthanyou
Saturday or Sunday depending on the time I can...

Saturday or Sunday depending on the time I can come over and check the plugs with you. Let's hope it's just a bad PCV. Intake leaks mean that cylinder is getting more air than the others. It's more...
Forum: Electrical and Wiring 06-07-2005, 06:20 PM
Replies: 4
Views: 5,932
Posted By Fasterthanyou
unfortunatly at this time none of the big 3...

unfortunatly at this time none of the big 3 tuning programs ie
hptuners
efilive
carputing

offer tuning options for the newer duramax diesels hptuners has been talking about doing it so we'll...
Forum: Electrical and Wiring 06-06-2005, 02:07 PM
Replies: 26
Views: 11,318
Posted By Fasterthanyou
Use your common sence. What do you THINK the ecm...

Use your common sence. What do you THINK the ecm has the ability to do. Does it control fuel? spark? air? Here's a hint, one of those 3 things doesn't belong :) . You really shouldn't waste your...
Forum: Engine / Power / Tuning 06-04-2005, 10:49 PM
Replies: 8
Views: 3,154
Posted By Fasterthanyou
You've got lots of options. I had the same...

You've got lots of options. I had the same dilemma a couple years ago. My engine was overheating with and without the a/c on so I ditched it. Not to mention it didn't hold a charge worth a damn and I...
Forum: Transmission and Driveline 06-03-2005, 07:39 PM
Replies: 7
Views: 7,173
Posted By Fasterthanyou
You're forgetting the trans cooling lines. The...

You're forgetting the trans cooling lines. The trans itself is rather heavy. Getting the trans seperated from the engine will require you to have some ability to pull the trans straight back AND...
Forum: Appearance 06-02-2005, 10:05 PM
Replies: 13
Views: 3,604
Posted By Fasterthanyou
Sounds good. Finally some more real hot roders. ...

Sounds good. Finally some more real hot roders.
BTW, did anybody else notice that the Ford Explorer intake in the picture has a $310 Competition Cams Polymer Intake. If that's the explorer you guys...
Forum: Appearance 06-02-2005, 09:45 PM
Replies: 16
Views: 4,847
Posted By Fasterthanyou
Nice red anodized hood pins you got there Craig...

Nice red anodized hood pins you got there Craig :whip:

I've got clears that are waiting to go in. Still have to order the amber LED's to do it right.
Forum: Transmission and Driveline 06-02-2005, 09:41 PM
Replies: 7
Views: 7,173
Posted By Fasterthanyou
It certainly isn't an easy job when the engine...

It certainly isn't an easy job when the engine bay is as busy as yours. Getting to the upper bolts is a royal PITA. I'd find a local reputable shop that has old technitians. The older guys are more...
Forum: Brake, Chassis and Suspension Tech 06-02-2005, 02:20 AM
Replies: 9
Views: 3,948
Posted By Fasterthanyou
haha i hope your joking...lets not turn this...

haha i hope your joking...lets not turn this thread into the one on thirdgen where the guy asked if he can just remove his rear brakes :lol:[/quote]
Well top fuel and lawn mowers don't need front...
Forum: Transmission and Driveline 06-01-2005, 04:47 PM
Replies: 5
Views: 6,732
Posted By Fasterthanyou
Yeah, I need to get a hold of him ASAP.

Yeah, I need to get a hold of him ASAP.
Forum: Engine / Power / Tuning 05-31-2005, 05:55 PM
Replies: 5
Views: 2,509
Posted By Fasterthanyou
If the engine is too cool it will wear more and...

If the engine is too cool it will wear more and the parts won't be sealing as well as they would at the designed operating temp. Lots of tolerances get messed up when you run too cool. I like...
Forum: Electrical and Wiring 05-28-2005, 11:09 AM
Replies: 1
Views: 5,696
Posted By Fasterthanyou
1227730, I've got a list of their applications...

1227730, I've got a list of their applications somewhere on this computer that'll I'll post.
Use www.car-part.com to find an ecm and don't lock the search to that car model and it'll post up LOTS of...
Forum: Brake, Chassis and Suspension Tech 05-26-2005, 07:49 PM
Replies: 3
Views: 2,531
Posted By Fasterthanyou
I've used small pieces of cotten cloth coated in...

I've used small pieces of cotten cloth coated in JB weld to get some jobs done. I've also used cloth with Fiberglass resin to do some similar support work. It was only a temporary patch or something...
Showing results 51 to 75 of 192
Page 3 of 8 12 3 4567 Last »

 
Forum Jump
» Sponsor List














All times are GMT -5. The time now is 01:59 AM.

Contact Us - New Jersey F-Body Owners Association - Home of New Jersey's Camaros and Firebirds - Archive - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.