Quote:
Originally Posted by WayFast84
JZ, the 882's you have and what ever else, do you think it would be a reasonable amount to make it in the 11's all motor? I dont care if its an 11.9
How much money would the 882's be for the steam holes drilled?
|
the heads with steam holes and springs set at the correct pressure for the cam you want to use and cleaned guides lubed ready to go, the 882s were decked, guides machined topped for PC crane seals and installed, spring bases were matched to match valve heights, and heads were drilled and tapped for arp studs to use push rod guide plates new 3 angle valve job and all the valves were cut i did say i would also back cut the valves and when i do i will picture the ports so you can see the difference at .100 lift on the valve all for 200 bucks -- i dont have the push rod plates and only have 15 studs BUT i have a shop we work with i will be seeing the guy in a day or so and i might get another stud 3/8 top 7/16 bottom will try -- jz