[maroman88]

k i cleaned the MAF wire and reset the computer. only code 36 has come back up thus far.

Code 36- This code is related to the burn off relay failure. The ecm has failed to detect 12V on the black wire going back to ecm pin D12, when the relay is not energized. The most likely cause is a open black wire or orange power wire going back to a fusible link to the battery. If this code is present with codes 33 and 34, again as mentioned before, check all the connections and wiring.

ive got power to both orange wires and when i probe the black wire while the engine is running it causes a ground and makes it stall.

if i remember correctly the burnoff should engage after the motor is shut off? i dont think its engages, i dont feel the relay click