Quote:
Originally Posted by BonzoHansen
"Warning!!! The BCM will automatically program to the resistance of the ignition key resistor during the 1st time the ignition switch is turned to the RUN position
And this process can only be performed once per replacement BCM. "
So, for a retrofit, if you aren't using a vats key, how does one get around this?
|
figuring there has to be an in and out for the BCM to detect the ohms of resistance on the key, i woudl think you coudl just run the wires from each side into each other upon initial start up. the BCM woudl theoretically program itself for 0 resistance and that is all it would look for in the vats pins from then on.
sound logical or did i try to make it too simple?i am not a wiring guy, jsut seemed like a logical answer.