NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

ins0mnia24 · 10-02-2008, 04:24 PM

You should probably examine the wheel liners on the front of your car seeing that you have a 99 Camaro..
On my 2002 both front wheel liners at the front of the wheel well were molded with an angled flap that has a 1 1/2" gap to allow the air that comes in from the Air deflector that has a a vented grill, " Right below your parking lamps "
It takes that air that passes through and directs the air towards the brakes..
Along with the air passing through the foglight hole in the nose..
On my car I cut another Inch off of that flap on the wheel liner along with I have no front grill, so I bowled out some of the front Impact foam that is underneath the nose to channel more air through the nose..
You just have to be careful with how much you take out of the Impact foam because it also use's that spot to direct air up into the engine bay which fed the factory Intake lid set-up and probably cool the engine bay..

I use this for my front plate it folds and retracks underneath the nose of my car..
http://store.summitracing.com/partdetail.asp?autofilter=1&part=APR%2D400&N=700+4 294849006+4294847027+115&autoview=sku

10-02-2008, 04:24 PM	#4
ins0mnia24 Join Date: Aug 2005 Location: Millville & Little ferry New Jersey Posts: 454 iTrader: (2)	You should probably examine the wheel liners on the front of your car seeing that you have a 99 Camaro.. On my 2002 both front wheel liners at the front of the wheel well were molded with an angled flap that has a 1 1/2" gap to allow the air that comes in from the Air deflector that has a a vented grill, " Right below your parking lamps " It takes that air that passes through and directs the air towards the brakes.. Along with the air passing through the foglight hole in the nose.. On my car I cut another Inch off of that flap on the wheel liner along with I have no front grill, so I bowled out some of the front Impact foam that is underneath the nose to channel more air through the nose.. You just have to be careful with how much you take out of the Impact foam because it also use's that spot to direct air up into the engine bay which fed the factory Intake lid set-up and probably cool the engine bay.. I use this for my front plate it folds and retracks underneath the nose of my car.. http://store.summitracing.com/partdetail.asp?autofilter=1&part=APR%2D400&N=700+4 294849006+4294847027+115&autoview=sku __________________ 2002 Z/28 = Firemutt Racing 370 w/ Cam, Trick Flow heads, TPIS 90mm Intake & 90mm T.B., Vigilante 3600 t.c., Michael's Transmissions Built 4L60E. QTP Headers, Mufflex Stainless Y-pipe, Pypes Performance Exhaust, Moser 12-bolt w/ 33 spline axles,Truetrac & 3:73's., Spohn. Cartek Tuned... Last edited by ins0mnia24; 10-02-2008 at 04:47 PM.