Quote:
Originally Posted by MyFirstZ
Try letting them gravity bleed for a little and then just old fashion pump and hold. That's at least what I do when installing bbks here. They are brembos but shouldn't differ to much
|
I'll try that. Very small amount of fluid was coming out of the fronts, though. Perhaps the Motiv wasn't giving it enough pressure because if i closed the screw, a small burst of fluid would come out after and then taper off.
Quote:
Originally Posted by 198esp1
is the pedal soft on the first application then hard on the second pump
1. flush with a quality race brake fluid
2. check all sliders on all calipers, pad tapper
3. check front wheel bearings/ ask me how i know
4. check rear axles
5. could be a wrong caliper size pistons
|
Pedal is pretty soft on each application. Fluid is Motul 600 and everything looks good from what I can tell. Front hubs are both new, and rear axle was just rebuilt. BBK is f-body specific too, so I'm pretty sure its right.
Gonna pick up another bottle of Motul fluid and try again without the Motiv, I think. Don't really know what else to do.