[IROCZman15]

Had dropped the car off a few weeks ago at the fabrication shop. He had some other projects to finish, but once mine arrived at the shop it was in-line. Miro is a 1-man operation at his shop, but his quality of work is top-notch. He got a good amount of progress done this week, and if all goes well he will be finished with it by Friday of this week. Then my plans are to get the bars primed and painted. Swap the radiators. Get the 4 new Falken tires mounted, and get an alignment. After that I hope to get to a SCCA or MSNE autocross event at Giants Stadium before the UMI event in 1 months time.


Base plates installed (power wires were pulled away from the sheetmetal, that is not how they normally are routed):









He ensured all the interior panels fit and are fully removable with the bars in place, so in the event I ever need to take panels off there wont be any problems.