WTB: t56 pedals
 

I need some pedals for my t56 swap into my thirdgen. I recently pcs'ed to Louisiana for the Airforce so factor in a little shipping cost and let me know what you got.
Thanks,
Jeremy

Just saying...you can use your third gen pedals. Keep the third gen pedals and make the hydraulics work for you. If its an LT1 variant use a 86 Z24 Cavalier slave cylinder with the LT1 master. 4th gen pedals have reported problems with bracing and the holes not lining up. People have reported flexing firewalls due to that.

^100% Agree w/firewall flexing on 4th gen pedals. Use factory t5 pedals, or reenforce your firewall if you decide going t56 pedals. Its a known issue.

i have a set of t5 petals

how much shipped to 71105 chris?

Im using my t-5 pedals on a T-56.

i will let you know tomorrow

Ok guys iv been reading a MILLION different routes for pedals, and modifications.
If I use t5 pedals and all new t56 hydraulics what mods do I need to make those pedals engage smoothly?

and ill be looking forward to your pm tomorrow chris. Id text you but my phones broke, waiting on a replacement...might be a while.

Best solution;

From TGO.org

iv read ALOT of different solutions and by far this one is the best. THANKS polarbear.

Just to be clear to mod the pedal this way all i do is replace the pin with a thicker pin(3/8") ?

That is my understanding. I have a Tick Master to put in my 3rd gen and this is the way I was going to go. There is a small amount of welding involved though

Ihave the LS1 T56 pedal setup and a maybe a stock master cyl if youre interested.