need LS1 ABS bracket part

[V]

ok, this is probably a long shot but what the heck...

i need a little round rubber bushing/isolator that goes between the ABS mounting bracket and the ABS pump itself. There is a small "stand" on the bracket which this rubber piece goes on, when the pump goes in place it basically located it in the center and reduces vibration.

MUST be an LS1 style ABS system(99-02 V6 f bodies shoudl have the correct one as well. 93-97 is different i believe)

Here is a pic of the bracket, showing the "stand". I took my setup apart back in March and i cant find it now. The dealer would take forever probably...

[dan]

if the part is the same from a 98 trans am, i believe i can help you out
you need the actual piece pictured or?...

[V]

nah, the picture is what i have, there should be like a rubber "hat"/grommet type thign that fits over that middle little stand.

98 should be the same

If you pull the abs pump and bracket, when you unbolt the sides and seperate the two, you should see the rubber piece between.

[dan]

i gotta pull the shifter outta my t/a tomorrow..if its not super windy i'll tear into hte stuff under the hood tehre and let you knowthe condition of the rubber piece

[V]

TTT. dealer cant help at all

[dan]

havent had a chance to get my stuff tore apart but..i will let you know as soon as i do unless ya get another one in the meantime

[V]

TTT

i'll gladly pay $10 or so for this tiny rubber peice, i need it ASAP, im stuck without it


ok, i finally found a pic online of what i need. the picture shows the underside of an ABS unit(corvette shown but bushing is the same)...




right now i'm gonna rip my garage apart to TRY to find it... wish me luck...

EDIT, well i didnt find it, but i did learn each 98+ abs uniot has 3 of these bushings, 2 on the sides, and one on the bottom. I took a pic of one of the bushings to show exactly what i need. IF anyone is near a junkyard that has a 98+ 4th gen, LET ME KNOW, lol