| 
| 
	
		|  |  
	
	
		
	
	
	
		|  01-09-2012, 06:06 PM | #1 |  
	| Power Member / trans break does not equal transbrake 
				 
                                        
				Join Date: May 2009 Location: The Meadowlands 
					Posts: 4,534
				 | 
				
				Jeep Problems
			 
 
			
			ok first off yes, i do work at a jeep dealer, but i dont have work till tommaro and id like to get some opinions.
 so i finally got my jeep on the road today after fixing a little problem(TPS) i take it out for a ride and my trans is acting up pretty bad. it doesnt shift itself until redline, so that leaves me cruisin at a high RPM. i tried manually shifting it and it is the same verdict. anyone have any expirience with this in there jeeps? it doesnt slip at all. it just doesnt like to shift.
 
 -95 XJ 4.0/Auto
 
				__________________99 Z28 - SBE LS1/60e
 Motor - 10.84 @ 128 - 1.47 60'
 Nitrous - 10.16 @ 132 - 1.40 60"
 |  
	|   |   |  
	
		
	
	
	
		|  01-09-2012, 07:03 PM | #2 |  
	| Mongo the Meet Coordinator 
				 
                                        
				Join Date: May 2008 
					Posts: 16,941
				     
                                    
                                 | 
			
			3/4 clutch pack I would guess.
		 
				__________________ 
	Quote: 
	
		| 
					Originally Posted by KirkEvil  repo bigals turd gen and part it out to a loving home |  |  
	|   |   |  
	
		
	
	
	
		|  01-09-2012, 07:19 PM | #3 |  
	| 
				 
                                        
				Join Date: Jul 2009 Location: barnegat nj 
					Posts: 1,340
				     
                                    
                                 | 
			
			Unplug the main connector going into the trans. Then start jeep and put it in 1st. then prceed to drive manually shifting. If you manually shift it with harness unplugged it is electrical/sensor/solenoid problem. If it doen't shift, than its mechanical,ie: stuck valve,etc..
		 
				__________________ 
	South Jersey RacecraftQuote: 
	
		| 
					Originally Posted by SRGN  I never pulled into the staging beams at the track and saw a dyno in the other lane. |  |  
	|   |   |  
	
		
	
	
	
		|  01-09-2012, 08:29 PM | #4 |  
	| 
				 
                                        
				Join Date: Aug 2004 Location: North Jersey 
					Posts: 3,047
				     
                                    
                                 | 
			
			TV cable is too tight, binding, or disconnected. Since you just had the throttlebody off to change the TPS I'd look there first.
		 
				__________________ 
				Seeya, 
Steve R. in North Jersey 
'16 Go-Mango Dodge Charger R/T. It's so good to be back in a V8-powered, RWD car! 
 
Former Toy - '88 Monte SS  - had lots of mods...
			 |  
	|   |   |  
	
		
	
	
	
		|  01-09-2012, 08:56 PM | #5 |  
	| Power Member / trans break does not equal transbrake 
				 
                                        
				Join Date: May 2009 Location: The Meadowlands 
					Posts: 4,534
				 | 
			
			
	Quote: 
	
		| 
					Originally Posted by TPI Monte SS  TV cable is too tight, binding, or disconnected. Since you just had the throttlebody off to change the TPS I'd look there first. |  i was thinking it had something to do with that. i driven it around my block numerous times and it never did it. i swapped the whole TB accually off my friends truck and now it does it.
		 
				__________________99 Z28 - SBE LS1/60e
 Motor - 10.84 @ 128 - 1.47 60'
 Nitrous - 10.16 @ 132 - 1.40 60"
 |  
	|   |   |  
	
		
	
	
	
		|  01-09-2012, 09:11 PM | #6 |  
	| 
				 
                                        
				Join Date: Aug 2004 Location: North Jersey 
					Posts: 3,047
				     
                                    
                                 | 
			
			
	Quote: 
	
		| 
					Originally Posted by LS1ow  i was thinking it had something to do with that. i driven it around my block numerous times and it never did it. i swapped the whole TB accually off my friends truck and now it does it. |  Ah, definitely check it out then and make sure the TV cable is hooked up correctly and not too tight. Good luck!
		 
				__________________ 
				Seeya, 
Steve R. in North Jersey 
'16 Go-Mango Dodge Charger R/T. It's so good to be back in a V8-powered, RWD car! 
 
Former Toy - '88 Monte SS  - had lots of mods...
			 |  
	|   |   |  
	
		
	
	
	
		|  01-09-2012, 09:13 PM | #7 |  
	| Power Member / trans break does not equal transbrake 
				 
                                        
				Join Date: May 2009 Location: The Meadowlands 
					Posts: 4,534
				 | 
			
			ill check it out tommaro man! thanks !
		 
				__________________99 Z28 - SBE LS1/60e
 Motor - 10.84 @ 128 - 1.47 60'
 Nitrous - 10.16 @ 132 - 1.40 60"
 |  
	|   |   |  
	
		
	
	
	
		|  01-09-2012, 09:24 PM | #8 |  
	| 
				 
                                        
				Join Date: Aug 2004 Location: North Jersey 
					Posts: 3,047
				     
                                    
                                 | 
			
			
	Quote: 
	
		| 
					Originally Posted by LS1ow  ill check it out tommaro man! thanks ! |    No problem! Hey, which Jeep dealer do you work at? My wife has an '03 Liberty that needs to get the balljoint recall done.
		 
				__________________ 
				Seeya, 
Steve R. in North Jersey 
'16 Go-Mango Dodge Charger R/T. It's so good to be back in a V8-powered, RWD car! 
 
Former Toy - '88 Monte SS  - had lots of mods...
			 |  
	|   |   |  
	
		
	
	
	
		|  01-10-2012, 12:34 PM | #9 |  
	| Power Member / trans break does not equal transbrake 
				 
                                        
				Join Date: May 2009 Location: The Meadowlands 
					Posts: 4,534
				 | 
			
			
	Quote: 
	
		| 
					Originally Posted by TPI Monte SS    No problem! Hey, which Jeep dealer do you work at? My wife has an '03 Liberty that needs to get the balljoint recall done. |  Teterboro
 
so i started it today, and the Idle Problem was back. so i switched TBs back to the one it had and drove it, it eliminated the shifting problem.
 
but not im back to the idle problem   any ideas?
		 
				__________________99 Z28 - SBE LS1/60e
 Motor - 10.84 @ 128 - 1.47 60'
 Nitrous - 10.16 @ 132 - 1.40 60"
 |  
	|   |   |  
	
		
	
	
	
		|  01-10-2012, 01:40 PM | #10 |  
	| Meet Coordinator 
				 
                                        
				Join Date: Jan 2008 Location: brick/pt. pleasant beach 
					Posts: 19,370
				     
                                    
                                 | 
			
			Carbon build up? Keep throwing parts at it?
		 |  
	|   |   |  
	
		
	
	
	
		|  01-10-2012, 01:46 PM | #11 |  
	| Ayatollah of Rock N Rolla / Admin 
				 
                                        
				Join Date: Mar 2006 Location: Parts Unknown 
					Posts: 12,573
				     
                                    
                                 | 
			
			
	Quote: 
	
		| 
					Originally Posted by LS1ow  Teterboro 
so i started it today, and the Idle Problem was back. so i switched TBs back to the one it had and drove it, it eliminated the shifting problem.
 
but not im back to the idle problem   any ideas? |  What's the "idle problem"?
		 |  
	|   |   |  
	
		
	
	
	
		|  01-10-2012, 01:57 PM | #12 |  
	| Power Member / trans break does not equal transbrake 
				 
                                        
				Join Date: May 2009 Location: The Meadowlands 
					Posts: 4,534
				 | 
			
			wont hold an idle, sometime wont even start without giving it gas.  but if i hold the rpms at 1200 or any were else itll stay all day.
		 
				__________________99 Z28 - SBE LS1/60e
 Motor - 10.84 @ 128 - 1.47 60'
 Nitrous - 10.16 @ 132 - 1.40 60"
 |  
	|   |   |  
	
		
	
	
	
		|  01-10-2012, 01:58 PM | #13 |  
	| Power Member / trans break does not equal transbrake 
				 
                                        
				Join Date: May 2009 Location: The Meadowlands 
					Posts: 4,534
				 | 
			
			
	Quote: 
	
		| 
					Originally Posted by sweetbmxrider  Carbon build up? Keep throwing parts at it? |  yea im gunna clean it when i get home from work.
		 
				__________________99 Z28 - SBE LS1/60e
 Motor - 10.84 @ 128 - 1.47 60'
 Nitrous - 10.16 @ 132 - 1.40 60"
 |  
	|   |   |  
	
		
	
	
	
		|  01-10-2012, 01:59 PM | #14 |  
	| Ayatollah of Rock N Rolla / Admin 
				 
                                        
				Join Date: Mar 2006 Location: Parts Unknown 
					Posts: 12,573
				     
                                    
                                 | 
			
			
	Quote: 
	
		| 
					Originally Posted by LS1ow  yea im gunna clean it when i get home from work. |  I'd say that as well. Start by cleaning it. Can you reset the IAC and see what happens then?
		 |  
	|   |   |  
	
		
	
	
	
		|  01-11-2012, 06:15 PM | #15 |  
	| 
				 
                                        
				Join Date: Aug 2004 Location: North Jersey 
					Posts: 3,047
				     
                                    
                                 | 
			
			Any luck with cleaning yours today? Another idea - you can swap the TPS from your friends TB into yours and see if that works?
		 
				__________________ 
				Seeya, 
Steve R. in North Jersey 
'16 Go-Mango Dodge Charger R/T. It's so good to be back in a V8-powered, RWD car! 
 
Former Toy - '88 Monte SS  - had lots of mods...
			 |  
	|   |   |  
	
		
 
  
	
	
	
	
	| 
	|  Posting Rules |  
	| 
		
		You may not post new threads You may not post replies You may not post attachments You may not edit your posts 
 HTML code is Off 
 |  |  |  | 
 |  |